[Users] Choosing which network to run VM migration on ovirt 3.1

Andreas Huser ahuser at 7five-edv.de
Sun Jan 6 21:05:09 UTC 2013


Hi Yuval

i think migrate was only the RAM not die virtual hard disk.
For so an scenario you need one separate Ovirt Engine (Management) one separate Storage and two Ovirt Nodes. 
An then you can build a HA Solution to reduce a Node failure. the single point of failure there will still give 
Eg. Storage, Ovirt Engine and Network.  But i think you can cluster the application and storage from the nodes. Using drbd, ucarp, etc. 

greeting Andreas 




----- Ursprüngliche Mail ----- 

Von: "Yuval M" <yuvalme at gmail.com> 
An: users at ovirt.org 
CC: "Limor Gavish" <lgavish at gmail.com> 
Gesendet: Sonntag, 6. Januar 2013 21:08:48 
Betreff: [Users] Choosing which network to run VM migration on ovirt 3.1 


Hi, 
I'm running the following setup: 
2 hosts, 
each has 2 physical NICs, 
the first NIC (which is bridged to ovirtmgmt) is a 100Mbps ethernet card connected to a switch (and to the internet) 
the 2nd NIC is a fast Infiniband card which is connected back-to-back to the other host. 


both links are running fine, and I managed to have the 2nd host mount the storage via the fast link. 
The problem is that VM migration takes place over the slow link. 


How do I configure the cluster so that the migration uses the fast link? 
I've already created a network using the web interface. the migration still uses the slow link. 




Thanks, 


Yuval 


_______________________________________________ 
Users mailing list 
Users at ovirt.org 
http://lists.ovirt.org/mailman/listinfo/users 



More information about the Users mailing list