[Users] NIC problem with ovirt node

Jason Keltz jas at cse.yorku.ca
Fri Jul 12 17:22:25 UTC 2013


On 12/07/2013 12:55 PM, Mike Burns wrote:
>> What IS a big deal is that every time I configure one network interface,
>> the others go back to "unconfigured".  I'm told this is because I should
>> only configure one on the ovirt-node, and then use the engine to
>> configure the rest.  Okay -- does it say that somewhere that I missed?
>
> There should be a warning that configuring a new nic will disable 
> previously configured nics.
>
Nope.. no warning whatsoever...

>> :)   but when I'm in the engine, I can click on the node, and see that
>> it's up.  I can click on network interfaces, and see that one is up, and
>> the other are down.  I can create networks on the engine, and I can
>> assign the nodes interfaces to those networks, but for the life of me, I
>> can't figure out where I assign an IP to the nodes interfaces!! Surely,
>> the place to do that would be under the "Host" tab, yet it doesn't seem
>> to be there...
>
> Host Tab -> Network Interfaces -> click on Setup Host Networks
>
> On the popup, hover over the logical network (not the nic) and a 
> little pencil or pen (or some other graphic) that is used for 
> editing.  Click on that and you'll get another popup where you can 
> choose static/dhcp and set gateway, ip and netmask.
>
Thank you *so* much!  I did not see the little pencil!!!

Jason.




More information about the Users mailing list