[Users] NIC problem with ovirt node

[Mike Burns]

On 07/12/2013 01:22 PM, Jason Keltz wrote:
> On 12/07/2013 12:55 PM, Mike Burns wrote:
>>> What IS a big deal is that every time I configure one network interface,
>>> the others go back to "unconfigured".  I'm told this is because I should
>>> only configure one on the ovirt-node, and then use the engine to
>>> configure the rest.  Okay -- does it say that somewhere that I missed?
>>
>> There should be a warning that configuring a new nic will disable
>> previously configured nics.
>>
> Nope.. no warning whatsoever...

Ah, bad memory on my part.  It was there in an older release, but the 
one you're running had a new UI framework and this was missed.  It's 
definitely something we will be adding back.

>
>>> :)   but when I'm in the engine, I can click on the node, and see that
>>> it's up.  I can click on network interfaces, and see that one is up, and
>>> the other are down.  I can create networks on the engine, and I can
>>> assign the nodes interfaces to those networks, but for the life of me, I
>>> can't figure out where I assign an IP to the nodes interfaces!! Surely,
>>> the place to do that would be under the "Host" tab, yet it doesn't seem
>>> to be there...
>>
>> Host Tab -> Network Interfaces -> click on Setup Host Networks
>>
>> On the popup, hover over the logical network (not the nic) and a
>> little pencil or pen (or some other graphic) that is used for
>> editing.  Click on that and you'll get another popup where you can
>> choose static/dhcp and set gateway, ip and netmask.
>>
> Thank you *so* much!  I did not see the little pencil!!!

Happy to help (and yes it was hard to see...)

Mike

>
> Jason.
>
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users