[Users] NIC problem with ovirt node

[Itamar Heim]

On 07/12/2013 11:27 PM, Jason Keltz wrote:
> On 12/07/2013 1:27 PM, Mike Burns wrote:
>> On 07/12/2013 01:22 PM, Jason Keltz wrote:
>>
>>>>> :)   but when I'm in the engine, I can click on the node, and see that
>>>>> it's up.  I can click on network interfaces, and see that one is
>>>>> up, and
>>>>> the other are down.  I can create networks on the engine, and I can
>>>>> assign the nodes interfaces to those networks, but for the life of
>>>>> me, I
>>>>> can't figure out where I assign an IP to the nodes interfaces!!
>>>>> Surely,
>>>>> the place to do that would be under the "Host" tab, yet it doesn't
>>>>> seem
>>>>> to be there...
>>>>
>>>> Host Tab -> Network Interfaces -> click on Setup Host Networks
>>>>
>>>> On the popup, hover over the logical network (not the nic) and a
>>>> little pencil or pen (or some other graphic) that is used for
>>>> editing.  Click on that and you'll get another popup where you can
>>>> choose static/dhcp and set gateway, ip and netmask.
>>>>
>>> Thank you *so* much!  I did not see the little pencil!!!

please open a bug to improve the usability if you couldn't see it...

>>
>> Happy to help (and yes it was hard to see...)
>>
> Actually, Mike -- two of my networks were private and didn't need a
> gateway... but two are public, and need a gateway!  Unfortunately, the
> interface seems to be missing that option!?  It lets you configure an
> IP, and a subnet mask, but where's the option for specifying a gateway
> if you're specifying static addresses... (my guess is that it picks up
> the gateway if you're using DHCP).

multiple gateways?
something like this?
http://www.ovirt.org/Features/Multiple_Gateways