[Users] Created ovirt 3.3 node (3.1 hypervisor) ISO but not 100% right?

[Schorschi]

I created ovirt node ISO but it is not 100% right.  Boots, media check is
fine, the UI executes, can select disk device as expected, enter password,
etc.  When the install sequence starts. it just stops at 0% "Starting." then
nothing happens. Tried it with IDE, SATA, even SCSI, all local attached,
even tried it in a VM (nesting enabled, etc.), and same issue appears to
freeze.  Jumping to alternate consoles, all blank.  Tried to run install in
text mode, removed quiet and rhgb options from boot command-line, but the UI
takes over so no help.  When I generated the ISO image, did not notice any
errors, source platform for ISO image was Fedora 19 minimal install plus all
the adds as outlined on the ovirt node build documentation web page.  Anyone
run into the same odd issue?  Am able to install Fedora 19 on same hardware,
so can't see why node install would fail, since am able to select disk
drive, but can't write to it?  Very odd.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20130916/3cb70a12/attachment-0001.html>