[Users] Created ovirt 3.3 node (3.1 hypervisor) ISO but not 100% right?

[Fabian Deutsch]

Am Montag, den 16.09.2013, 20:03 -0700 schrieb Schorschi:
> I created ovirt node ISO but it is not 100% right.  Boots, media check
> is fine, the UI executes, can select disk device as expected, enter
> password, etc.  When the install sequence starts… it just stops at 0%
> “Starting…” then nothing happens. Tried it with IDE, SATA, even SCSI,
> all local attached, even tried it in a VM (nesting enabled, etc.), and
> same issue appears to freeze.  Jumping to alternate consoles, all
> blank.  Tried to run install in text mode, removed quiet and rhgb
> options from boot command-line, but the UI takes over so no help.
> When I generated the ISO image, did not notice any errors, source
> platform for ISO image was Fedora 19 minimal install plus all the adds
> as outlined on the ovirt node build documentation web page.  Anyone
> run into the same odd issue?  Am able to install Fedora 19 on same
> hardware, so can’t see why node install would fail, since am able to
> select disk drive, but can’t write to it?  Very odd.

Hey,

could it be that you build the iso using the git master branch of that
day?
Because it sounds much like [0] (which is fixed by now, in master).

You should be able to build a working node using the release tags
(ovirt-node-3.0.1 is the latest). Building from master is not guaranteed
to produce a working iso.

Greetings
fabian

---
[0] https://bugzilla.redhat.com/show_bug.cgi?id=1007811