[Users] Unable to finish AIO 3.3.0 - VDSM

[Jason Brooks]

----- Original Message -----
> From: "Nicholas Kesick" <cybertimber2000 at hotmail.com>
> To: "oVirt Mailing List" <users at ovirt.org>
> Sent: Monday, September 23, 2013 7:52:17 AM
> Subject: [Users] Unable to finish AIO 3.3.0 - VDSM
> 
> I'm having trouble with the AIO 3.3.0 install on Fedora 19 using jbrooks
> directions - I have DHCP, so I omitted the NM portion.
> The good news is that the engine-setup completes just fine, but the VDSM
> portion fails. I thought it had to do with a missing dependency but so far
> that hasn't helped either. Does anyone have any suggestions?
> 
> The install is a Fedora 19 "minimal" install with the "standard" package of
> add-ons. I've tried with and without SELINUX in permissive. The only thing I

Hi Nicholas, I just installed an F19 AIO without any problem. My install was
only minimal, though. I restored my snapshot to pre-ovirt install and added
the "standard" group, rebooted, installed, and vdsm still installed normally.

I'm wondering if it makes a difference if the system starts out with 
minimal+standard, rather than starting out minimal and adding standard after...

This is with dhcp addressing.

Jason

> have noticed is that the ovirtmgmt network is missing. When I try to
> activate the host using the web interface ovirtmgmt appears, but without an
> IP address, so the entire system loses connectivity.
> 
> ovirt-engine-setup and vdsm log are attached and compressed.
> 
> 
> 
> 
> 
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>