[Users] Unable to finish AIO 3.3.0 - VDSM

[Jason Brooks]

> 
> Hi Nicholas, I just installed an F19 AIO without any problem. My install was
> only minimal, though. I restored my snapshot to pre-ovirt install and added
> the "standard" group, rebooted, installed, and vdsm still installed normally.
> 
> I'm wondering if it makes a difference if the system starts out with
> minimal+standard, rather than starting out minimal and adding standard
> after...
> 
> This is with dhcp addressing.

Another difference -- my AIO machine has nics w/ the regular eth0 naming --
don't know if the biosdevname bits could be causing an issue...


> 
> Jason
> 
> > have noticed is that the ovirtmgmt network is missing. When I try to
> > activate the host using the web interface ovirtmgmt appears, but without an
> > IP address, so the entire system loses connectivity.
> > 
> > ovirt-engine-setup and vdsm log are attached and compressed.
> > 
> > 
> > 
> > 
> > 
> > _______________________________________________
> > Users mailing list
> > Users at ovirt.org
> > http://lists.ovirt.org/mailman/listinfo/users
> > 
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>