[Users] Problem setting up a ovirt node / engine on a Minimal CentOS 6.5

[Sven Kieske]

So you wanted to install engine and compute node (vdsm) on the same host?

If the anser to the above is yes you may want to checkout
the all-in-one installation option for ovirt-engine.

HTH

Am 21.02.2014 15:18, schrieb Andy Michielsen:
> Hello,
> 
> Maybe I'm not asking my question at the right guy's but here I go.
> 
> 
> I installed a clean CentOS 6.5 on a new DELL server and wanted to use it to
> install oVirt 3.3.x.x
> I changed the ifcfg-eth0 file to get it connected to the internet and did a
> yum -y update.
> 
> Then I added some repositories to get the oVirt packages :
> - yum -y install
> http://dl.fedoraproject.org/pub/epel/6/x86_64/epel-release-6-8.noarch.rpm
> - yum -y install
> http://resources.ovirt.org/releases/ovirt-release-el.noarch.rpm
> 
> Installed the ovirt engine first with yum -y install ovirt-engine and than
> run the setup by engine-setup.
> 
> So far so good.
> 
> I can log into the oVirt website and see that there is nothing there.
> 
> Then I want to install yum -y install vdsm vdsm-cli and wanted to add the
> ifcfg-ovirtmgmt bridge and that's where thing go wrong.
> 
> Obviously I did something wrong but I don't know what. Any help would be
> greatly appriciated.
> 
> Kind regards.

-- 
Mit freundlichen Grüßen / Regards

Sven Kieske

Systemadministrator
Mittwald CM Service GmbH & Co. KG
Königsberger Straße 6
32339 Espelkamp
T: +49-5772-293-100
F: +49-5772-293-333
https://www.mittwald.de
Geschäftsführer: Robert Meyer
St.Nr.: 331/5721/1033, USt-IdNr.: DE814773217, HRA 6640, AG Bad Oeynhausen
Komplementärin: Robert Meyer Verwaltungs GmbH, HRB 13260, AG Bad Oeynhausen