[Users] Network profile lost after host edit

[Simon Barrett]

I am now able to reproduce the problem where network profile definitions are lost on VM edit.

- Create VM
- From the "Network Interfaces" tab, click on "New" and assign the ovirtmgt profile to nic1
- Edit VM, from the "nic1" drop down select another profile and click OK
- Edit the same VM again and nic1 lists as <Empty>

I upgraded to 3.3.2-1.el6 and still see the problem.

As ever, any help is very much appreciated.

Thanks,

Simon


-----Original Message-----
From: users-bounces at ovirt.org [mailto:users-bounces at ovirt.org] On Behalf Of Simon Barrett
Sent: 12 December 2013 21:53
To: Lior Vernia
Cc: users at ovirt.org
Subject: Re: [Users] Network profile lost after host edit

Lior,

I'm running 3.3.1.

I think it may be related to how I created the VM's. Another VM created using the blank template works fine and the network config displays correctly when I click on edit. 

The problem VM's were created with a different template. I'll dig a bit further to see if I can narrow it down any further. 

I don't have to click show advanced to exhibit the problem.

Thanks for the response 

Simon

> On 12 Dec 2013, at 16:44, "Lior Vernia" <lvernia at redhat.com> wrote:
> 
> Hi Simon,
> 
> I apologize for the delay in my response. I've worked quite a bit on 
> that part of the dialog since oVirt 3.3, and while it was quite buggy 
> I haven't encountered this exact issue you're describing. It does 
> remind me of one bug though; could it be that pressing the "Show 
> Advanced Options" is what triggers the strange behavior?
> 
> What version of oVirt engine are you running? Both 3.3.1 and 3.3.2 
> should be quite stable as far as this dialog is concerned, so 
> upgrading might be a good idea.
> 
> As for workarounds, it sounds like a GUI issue so I don't think 
> there's anything you can do apart from upgrading the engine.
> 
> Yours, Lior.
> 
>> On 11/12/13 13:40, Simon Barrett wrote:
>> I have a problem where VM network profiles are lost when editing a host.
>> E.G.
>> 
>> 
>> 
>> *         VM is running fine on the correct network. Network Interfaces
>> tab shows "nic1" and "Network Name" shows the correct network profile.
>> 
>> *         I shutdown the VM then right click and Edit.
>> 
>> *         The General settings for the node shows "nic1 <Empty>". If I
>> then edit config, something like increasing memory or changing CPU 
>> cores then click on OK, the VM configuration is saved without a network profile.
>> 
>> *         When I boot the VM I cannot connect to it.
>> 
>> *         I then have to edit the node again configure back in the
>> correct network profile.
>> 
>> 
>> 
>> Does anyone know if this is a known issue? If not, any suggestions as 
>> to how I correct this so that the original network profile definition 
>> is retained after an edit?
>> 
>> 
>> 
>> Many thanks,
>> 
>> 
>> 
>> Simon
>> 
>> 
>> 
>> 
>> 
>> _______________________________________________
>> Users mailing list
>> Users at ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/users
>> 
_______________________________________________
Users mailing list
Users at ovirt.org
http://lists.ovirt.org/mailman/listinfo/users