[ovirt-users] Network setup

[Karli Sjöberg]

Den 5 jul 2014 05:06 skrev Dwight Schauer <d.schauer at partner.samsung.com>:
>
> Hello oVirt users,
>
> I'm  running into network setup problems.
>
> http://www.ovirt.org/Vdsm_Network
>
> Shows this as a supported topology.
>
> bridge1 --- v1 --- bond --- nic1
> bridge2 --- v2 --/      \-- nic2
>
> Problem is I have to configure at least this on each host in order to the connect to an activate:
>
> v1 --- bond --- nic1
>               \-- nic2
>
> Which oVirt does not like because I already created the bond and attached a vlan interface to it.
>
> So I configured this ahead of time (without vdsm)
>
> bridge1 --- v1 --- bond --- nic1
> bridge2 --- v2 --/      \-- nic2
>
> Those work fine. I can use each bridge statically or with DHCP.
>
> Problem is that oVirt refuses to use the bridge interfaces (they don't show up in the web gui), it only wants to use the bond interface.
>
> If I was using libvirt/kvm-manager I would preconfigure this (without vdsm):
>
> bridge1 --- v1 --- bond --- nic1
> bridge2 --- v2 --/      \-- nic2
>
> And I'm be able to run VMs  on other VLAN. (Which is what I want to achieve with oVirt).
>
> Is there a way I can achieve what I need to do (connecting VMs to either VLAN) with one of my preconfigured setups without resorting to another nic (or bonded pair?)
>
> --
> Dwight
>

Have you restarted the "vdsmd" ?

/K
_______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20140705/2b4174ea/attachment-0001.html>