[ovirt-users] Network setup

[Dwight Schauer]

On Mon, 2014-07-07 at 10:52 +0100, Dan Kenigsberg wrote:
> On Sat, Jul 05, 2014 at 03:05:51AM +0000, Dwight Schauer wrote:
> > Which oVirt does not like because I already created the bond and attached a vlan interface to it.
> 
> What do you mean by "not like"? If v1 has an IP address attached to it,
> you should be able to add this host to an oVirt cluster.

By "not like" I mean I can try to configure oVirt networking but it
won't work with the way I had it set up.


> I would not recommend this, but you could define a libvirt network per
> bridge to make it show in the web gui:
>     <network>
>       <name>vdsm-bridge1</name>
>       <forward mode='bridge'/>
>       <bridge name='bridge1' />
>     </network>

Thanks. I don't think I'll need to use that since I've found that if I
use an initial vlan interface with an id I won't be using in the oVirt
networking setup then I don't run into problems. While I need to have
some initial network pre-configuration, I've found out who to do it in a
way that oVirt will accept and work with.

--
Dwight