[Users] Glusterd en Glusterfsd services are not set to autostart on install

[Alon Bar-Lev]

----- Original Message -----
> From: "Joop" <jvdwege at xs4all.nl>
> To: users at ovirt.org
> Sent: Friday, March 28, 2014 11:29:53 PM
> Subject: Re: [Users] Glusterd en Glusterfsd services are not set to autostart on install
> 
> Sahina Bose wrote:
> >
> > On 03/28/2014 05:26 PM, Joop wrote:
> >> On 28-3-2014 12:38, Sahina Bose wrote:
> >>>
> >>> On 03/28/2014 04:02 PM, Joop wrote:
> >>>> Setting up oVirt with a separate cluster for storage using gluster
> >>>> we discovered that the gluster services are not set to autostart
> >>>> for the default runlevels.
> >>>> Host(s) were clean Centos-6.5 hosts with the correct repositories
> >>>> and then added from the webui. Hosts got all the packages and
> >>>> gluster was correctly started for that session but after a reboot
> >>>> gluster isn't running and the host was set to non-operational.
> >>>>
> >>>> Is this a known problem and if not should I file a BZ but under
> >>>> which category?
> >>>
> >>> Which version of gluster are you using?
> >>>
> >>> [Adding gluster-users]
> >>>
> >>>
> >> Sorry, the version that comes with the repos ovirt.repo and epel so
> >> 3.4.2. Version shouldn't matter because I expect that the hostdeploy
> >> from ovirt-engine to take care of making sure that glusterd and
> >> glusterfsd are started on system startup.
> >
> > I think the chkconfig values are set by gluster rpm - which is why I
> > added gluster users.
> >
> > AFAIU, host-deploy installs the rpm and starts the services after
> > installation, but does not change the chkconfig value.
> >
> Thats correct host-deploy starts the services but doesn't change the
> chkconfig value and my collegues get bitten by it. They are used to
> Debian/Ubuntu where packages which install services (almost) always make
> sure that they are started at boot. I noticed in CentOS that is normally
> not the case, oVirt being the exception :-)

This should be dependency of vdsm, not directly related to host-deploy.

Yaniv, I do not see gluster services at sysv service:

NEEDED_SERVICES="multipathd rpcbind ntpd wdmd sanlock network libvirtd
                 supervdsmd"

If it is required by vdsm it should be either listed explicitly or started implicitly.

> 
> Regards,
> 
> Joop
> 
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>