[ovirt-users] Running a Gluster volume off of a seperate network interface and managing it via the oVirt engine Web-GUI

[Kanagaraj Mayilsamy]

You can refer http://www.ovirt.org/Change_network_interface_for_Gluster

Thanks,
Kanagaraj

----- Original Message -----
> From: "Thomas Keppler (PEBA)" <thomas.keppler at kit.edu>
> To: users at ovirt.org
> Sent: Thursday, October 9, 2014 7:36:51 PM
> Subject: [ovirt-users] Running a Gluster volume off of a seperate network interface and managing it via the oVirt
> engine Web-GUI
> 
> Hello!
> 
> I have a rather quick question on behalf of GlusterFS. My Nodes are set up so
> that they have two NICs, four ports. The NIC that is additionally installed
> to the internal motherboard's NIC is a 10Gbps one that I want to use for
> Gluster-Communication in the GlusterCluster.
> 
> Now, I could just create a plain old Gluster Volume and run everything off of
> the terminal and be good with it but that's really not what I want to do! I
> want to manage as much as possible through the oVirt engine and I saw it's
> possible to manage Gluster Volumes, too.
> If I try to create one there though, I can only see the IP addresses I used
> to communicate with oVirt (on the internal 1Gbps NIC).
> 
> I have tried creating another network and bound all my nodes to it - still no
> success.
> 
> Any ideas how I can do this?
> 
> --
> Best regards
> Thomas Keppler
> 
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>