[ovirt-users] question on VM
Bill Dossett
bill.dossett at pb.com
Wed Sep 24 07:55:21 UTC 2014
In the end, I it was the network bonding of the pnics. I changed from method 2 to method 5 I think. I haven't had time to read up on the methods to see which if any need additional configuration on the switch. Changed to active/backup first and then it started working, then changed to 5 I think active load balancing and that also worked. The 2 load balance option sounded similar to vmware's simplest 'works on everything' setup, which was why I tried that. Anyway, all good now
Thanks
-----Original Message-----
From: Lior Vernia [mailto:lvernia at redhat.com]
Sent: 23 September 2014 19:44
To: Bill Dossett
Cc: users at ovirt.org
Subject: Re: [ovirt-users] question on VM
Hi Bill,
So without firewall you can ping interfaces inside the cluster but nothing outside? Could it be that your DHCP server is allocating internal network addresses and you need to configure NAT?
Yours, Lior.
On 23/09/14 08:45, Bill Dossett wrote:
> In the absence of any comment and continued testing I have found that
> I can ping the host network IP that the VM is running on... and the host
> can ping the VM. So it would appear that nothing is wrong with the
> VM... I could only ping the host from the VM once I stopped iptables, so
> the firewall was stopping that. But I still can't ping outside of the
> host or ping the VM from elsewhere... and the VM continues to get an IP
> address from the DHCP server without issue. I have gone back to my
> networks and checked them thoroughly and can't see any issues, I have
> migrated the VM from one host to another and the condition persists in
> that it can ping the host that it is running on and the host can ping
> it (providing I turn off the firewall) numerous reboots etc and no
> change. L
>
>
>
> *From:*users-bounces at ovirt.org [mailto:users-bounces at ovirt.org] *On
> Behalf Of *Bill Dossett
> *Sent:* 22 September 2014 16:07
> *To:* users at ovirt.org
> *Subject:* [ovirt-users] question on VM
>
>
>
> Hi,
>
>
>
> I am creating my first ovirt VM from a windows 2008 R2 iso.
>
>
>
> After setting it all up, loading the drivers etc it looks fine, but it
> seems like it has no network connectivity. This is odd as it is
> obtaining a DHCP address and it looks like it can browse for other
> windows systems on the network. But I can't ping it, it can't ping
> out and I can't remote desktop into it. Normally this sounds like a
> firewall problem, but I disabled that immediately. It is using the
> virtio driver. It is connected to the default network ovirtmgmt which
> has a dhcp server on it. Ovirt-engine says the interface is up and
> connected and windows thinks it is connected to an unknown network
> with out internet access. I can't ping the default gateway from the
> VM console. Seems silly, but I've kind of run out of things to try on
> this now. I am using VLAN tagging on the ovirt-engine network side of
> things and it is plugged into a trunked port... but I wouldn't think
> that has anything to do with the VM itself as I am not doing anything
> with VLANs on the VM itself, it is just connected to it. All the host
> network/interfaces are pingable in the cluster as well.
>
>
>
> Thanks if anyone has any ideas what I might be looking for.
>
>
>
> *Bill Dossett*
>
> *Virtualisation Architect*
>
> *Pitney Bowes - Tech Central*
>
> 6 Hercules Way, 600 Leavesden Park
>
> Watford, WD25 7GS
>
> Phone(+44) (0)1923 279353 | VOIP: 54739353
>
> Mobile(+44) (0)7775 908612
>
> bill.dossett at pb.com <mailto:bill.dossett at pb.com>
>
> www.pb.com <http://www.pb.com/>
>
>
>
> *In Engineering?**Raise a ticket via Remedy Anywhere [HERE
> <http://teamsite.inside.pb.com/sites/TCPPM/GES/Lists/Create%20Incident
> /newIncident.aspx>]takes
> less than a minute*
>
>
>
> *ManageIQ User Guide available*[*HERE
> <https://dl.dropbox.com/u/6219441/ManageIQ%20-%20User%20Manual%20PB%20
> v4.pdf>*]
>
>
>
> *Check out the ManageIQ Blog for recent enhancements and information
> [HERE]
> <http://teamsite.inside.pb.com/sites/TCPPM/GES/manageiq/default.aspx>*
>
>
>
>
>
>
>
> ----------------------------------------------------------------------
> --
>
>
>
>
> ----------------------------------------------------------------------
> --
>
>
>
> _______________________________________________
> Users mailing list
> Users at ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>
________________________________
More information about the Users
mailing list