[ovirt-users] VDSM network persistence through re-install
Trey Dockendorf
treydock at gmail.com
Mon Jun 22 17:05:10 UTC 2015
Dan,
Thanks for the information. I'll follow that RFE. Being able to
re-provision a host and not have to remember the correct network interface
mapping for 10 interfaces would be a huge help...too much can go wrong if I
have to re-setup a config that I thought was saved in the engine.
Thanks,
- Trey
On Mon, Jun 22, 2015 at 3:35 AM, Dan Kenigsberg <danken at redhat.com> wrote:
> On Sat, Jun 20, 2015 at 12:28:10PM -0500, Trey Dockendorf wrote:
> > I recently found that when I reinstall a VDSM host via the engine
> > interface, if that host was actually re-provisioned via kickstart, the
> > network settings defined in the engine are lost. Before the re-install I
> > had defined 4 bonds and attached 5 logical networks to the host. After a
> > re-install only ovirtmgmt was attached to the node. Is it intended
> > behavior that a host's network configuration in the ovirt-engine be lost
> > when a host is re-provisioned ? If I have to re-deploy a node, is there
> a
> > way to make the ovirt-engine define networks for that host get applied to
> > the re-deployed system?
>
> Yes, this is the inteded behavior, though some consider this a design
> bug. Network config is persisted on each host, and Engine do not
> automatically applies its own definitions ona re-provisioned host,
> however, we have
>
> 1194297 [RFE] Allow to synchronize all networks on an
> out-of-sync host
>
> in the works, which would make life easier in such conditions.
>
> Dan.
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20150622/a15cb84d/attachment-0001.html>
More information about the Users
mailing list