[ovirt-users] connecting my oVirt engine to a 100mb switch

[Andrew Precht]

It is a hardware issue. Our pass-through's in the c7000 enclosures are not
capable of 10/100

On Thu, May 28, 2015 at 7:22 AM, Andrew Precht <andrewprecht06 at gmail.com>
wrote:

> The switch is a Cisco 3750 v2, I also tried a cheep Netgear. I'll put in a
> request to set the Cisco to 100 full and see if that helps.
> Thanks
>
> On Thu, May 28, 2015 at 6:24 AM, Genadi Chereshnya <gcheresh at redhat.com>
> wrote:
>
>> Hi Andrew
>> I am not aware of any issue to connect engine to specific switch (try to
>> connect other host to the switch to check this assumption)
>> Looks like it's auto-negotiation issue.
>> Try to disable it (on the switch side too)
>>
>> Regards,
>>    Genadi
>>
>> ----- Original Message -----
>> From: "Andrew Precht" <andrewprecht06 at gmail.com>
>> To: users at ovirt.org
>> Sent: Thursday, May 28, 2015 12:37:57 AM
>> Subject: [ovirt-users] connecting my oVirt engine to a 100mb switch
>>
>>
>>
>>
>> Hi all,
>> I’m having problems connecting my oVirt engine to a 100mb switch. I’m not
>> having any problems connecting to 1gb. But, I need to also have a
>> connection to a 100mb network.
>> I’ve tried configuring ethtool_opts on the interface. However, this only
>> results in the NIC not coming up and showing: Speed: Unknown! and Duplex:
>> Unknown! (255), when I run ethtool ethX
>>
>>
>> Is it possible to connect the engine to a 100mb switch?
>> Thanks
>>
>>
>> PS. I also posted this question over on the oVirt G+ page. I apologize if
>> that's incorrect but I have G+ open all day...
>> _______________________________________________
>> Users mailing list
>> Users at ovirt.org
>> http://lists.ovirt.org/mailman/listinfo/users
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ovirt.org/pipermail/users/attachments/20150528/667f9679/attachment.html>