[ovirt-users] connecting my oVirt engine to a 100mb switch

[Genadi Chereshnya]

I am glad you figured out what the problem is
Genadi

----- Original Message -----
From: "Andrew Precht" <andrewprecht06 at gmail.com>
To: "Genadi Chereshnya" <gcheresh at redhat.com>, Users at ovirt.org
Sent: Thursday, May 28, 2015 8:01:19 PM
Subject: Re: [ovirt-users] connecting my oVirt engine to a 100mb switch


It is a hardware issue. Our pass-through's in the c7000 enclosures are not capable of 10/100 



On Thu, May 28, 2015 at 7:22 AM, Andrew Precht < andrewprecht06 at gmail.com > wrote: 



The switch is a Cisco 3750 v2, I also tried a cheep Netgear. I'll put in a request to set the Cisco to 100 full and see if that helps. 
Thanks 




On Thu, May 28, 2015 at 6:24 AM, Genadi Chereshnya < gcheresh at redhat.com > wrote: 


Hi Andrew 
I am not aware of any issue to connect engine to specific switch (try to connect other host to the switch to check this assumption) 
Looks like it's auto-negotiation issue. 
Try to disable it (on the switch side too) 

Regards, 
Genadi 



----- Original Message ----- 
From: "Andrew Precht" < andrewprecht06 at gmail.com > 
To: users at ovirt.org 
Sent: Thursday, May 28, 2015 12:37:57 AM 
Subject: [ovirt-users] connecting my oVirt engine to a 100mb switch 




Hi all, 
I’m having problems connecting my oVirt engine to a 100mb switch. I’m not having any problems connecting to 1gb. But, I need to also have a connection to a 100mb network. 
I’ve tried configuring ethtool_opts on the interface. However, this only results in the NIC not coming up and showing: Speed: Unknown! and Duplex: Unknown! (255), when I run ethtool ethX 


Is it possible to connect the engine to a 100mb switch? 
Thanks 


PS. I also posted this question over on the oVirt G+ page. I apologize if that's incorrect but I have G+ open all day... 
_______________________________________________ 
Users mailing list 
Users at ovirt.org 
http://lists.ovirt.org/mailman/listinfo/users