[ovirt-devel] Re: Cannot install latest oVirt engine

Hi, > I'm trying to install engine build [1] to verify test a patch [2], but I'm > getting following error: I was bale to install the engine, but adding new hosts fails with 2021-09-21 03:52:15 EDT - TASK [ovirt-provider-ovn-driver : Configure OVN for oVirt] ********************* 2021-09-21 03:52:15 EDT - 2021-09-21 03:52:15 EDT - fatal: [192.168.122.201]: FAILED! => {"changed": true, "cmd": ["vdsm-tool", "ovn-config", "192.168.122.192", "192.168.122.201", "192.168.122.201"], "delta": "0:00:00.355651", "end": "2021-09-21 03:52:13.433094", "msg": "non-zer o return code", "rc": 1, "start": "2021-09-21 03:52:13.077443", "stderr": "usage: \n /usr/bin/vdsm-tool [options] ovn-config IP-central [tunneling-IP|tunneling-network]\n Configures the ovn-controller on the host.\n\n Parameters:\n IP-central - the IP of the engine (the host where OVN central is located)\n tunneling-IP - the local IP which is to be used for OVN tunneling\n tunneling-network - the vdsm network meant to be used for OVN tunneling\n ", "stderr_lines": ["usage: ", " /usr/ bin/vdsm-tool [options] ovn-config IP-central [tunneling-IP|tunneling-network]", " Configures the ovn-controller on the host.", "", " Parameters:", " IP-central - the IP of the engine (the host where OVN central is located)", " tunneling-IP - the local IP which is to be used for OVN tunneling", " tunneling-network - the vdsm network meant to be used for OVN tunneling", " "], "stdout": "", "stdout_lines": []} There's additional 192.168.122.201 and the command should be vdsm-tool ovn-config 192.168.122.192 192.168.122.201 I can run it manually, but the network is not configured properly as the host setup fails always at this point. Again some issue on my side or is this a known issue? Is there any workaround for it? Thanks for hits. Vojta