Hello Zois, It pretty easy to do, via the webadmin UI , go to Hosts main tab > Choose host > go to 'Network Interfaces' sub tab > Press the 'Setup Host Networks' button > press the pencil icon on your management network > and choose Static IP > press OK and OK to approve the operation. - Note that in some cases, specially if this is a SPM host you will loose connectivity to host for few seconds and host may go to non-responsive state, on a non-SPM host usually this woks without any specific issues. - If the spoken host is a SPM host, I recommend to set it first to maintenance mode, do the switch and then activate. For non-SPM host this will work fine as well when the host is UP. Cheers) On Mon, Mar 19, 2018 at 12:15 PM, zois roupas <roupas_zois@hotmail.com> wrote:
Hello everyone
I've made a rookie mistake by installing ovirt 4.2 in centos 7 with dhcp instead of a static ip configuration. Both engine and host are in the same machine cause of limited resources and i was so happy that everything worked so well that i kept configuring and installing vm's ,adding local and nfs storage and setting up the backup!
As you understand i must change the configuration to static ip and i can't find any guide describing the correct procedure. Is there an official guide to change configuration without causing any trouble?
I've found this thread http://lists.ovirt.org/pipermail/users/2014-May/ 024432.html but this is for a hosted engine and doesn't help when both engine and host are in the same machine
Thanx in advance
Best Regards
Zois
_______________________________________________ Users mailing list Users@ovirt.org http://lists.ovirt.org/mailman/listinfo/users
-- Michael Burman Senior Quality engineer - rhv network - redhat israel Red Hat <https://www.redhat.com> mburman@redhat.com M: 0545355725 IM: mburman <https://red.ht/sig>