hey thanks for the answer. 1. where exactly do i see the state of the host 2. I did as you instructed. the setup fails exactly at the same step (I changed the timeout to 600, shut down networkmanager and connected via dhcp over ethernet. 2. I manually configured as following /etc/sysconfig/network-scripts/ifcfg-ovirtmgmt DEVICE=ovirtmgmt TYPE=Bridge ONBOOT=yes DELAY=0 BOOTPROTO=dhcp NM_CONTROLLED="no and added BRIDGE=ovirtmgmt to the ifcfg-eth0 restarting the network service fails with a status error RTNETLINK answers: File exists. thanks On Mon, Jun 18, 2012 at 11:21 AM, Ofer Schreiber <oschreib@redhat.com>wrote:
the bootstrap logs are also available here they are. thanks.
1. If you log into the GUI, in which state is the host?
2. From the engine.log, I can see that the host installation went fine, and it seems that the host is in "Non-Operetional state). - I can see clearly in the log :"Host local_host is set to Non-Operational, it is missing the following networks: ovirtmgmt"
3. in the vds_bootstrap.498578.log you can see "ERROR _getBridgeParams: failed to read params of file /etc/sysconfig/network-scripts/ifcfg-wlan0." - it seems that something is wrong with your networking configuration
4. Probably the timeout during all-in-one installation (150 seconds) is too low for you.
Two options for you: 1. Clean everything (using engine-cleanup), fix you networking settings (disable NetworkManager, use non wireless conntection) and rerun engine-setup (with higher timeout in /usr/share/ovirt-engine/scripts/plugins/all_in_one_100.py)
2. Just create the ovirtmgmt network bridge by your self, and restart vdsm.
On Mon, Jun 18, 2012 at 10:40 AM, Ofer Schreiber < oschreib@redhat.com > wrote:
----- Original Message -----
The log is attached.
thanks
I'm missing the vds_bootstrap* logs. are they available? if not, if you log into the GUI, in which state the host is currently at?
(/var/log/ovirt-enging/*log might help as well)
On Mon, Jun 18, 2012 at 10:26 AM, Ofer Schreiber < oschreib@redhat.com > wrote:
It seems that the host is currently in "installing" state. Could you please take a look (or attach us) the vdsm installation logs under /tmp? (/tmp/vds_*)
----- Original Message -----
Hello.
I'm experiencing a problem during installation of the ovirt engine including the all-in-one plugin The setup exists during the stage "Adding local host" - it quits due to a "time out while waiting for the host to start" I've attached some info (including the setup's log) and will gladly provide more information if necessary.
Many thanks,
Ohad