[ovirt-users] Re: oVirt HCI point-to-point interconnection

Good morning, I would like to kindly ask you a question about the feasibility of defining a point-to-point interconnection between three ovirt nodes. Initially with the idea of optimizing the direct communications between the nodes and especially the gluster communications, and so it would seem quite easy, then evaluating a more complex configuration, assuming to create an overlay L2 network on the three L3 point-to-point, using techniques like geneve, of which at the moment I have no mastery. If the direct routing of three nodes to interconnect the public network with the private overlay network was not easily doable, we could leave the private overlay network isolated from the outside world and connect the VM hosted engine directly to the two networks with two adapters. This layout with direct interconnection of the nodes without switches and a shared L2 overlay network between the nodes may in future be contemplated in future releases of your HCI solution? Thank you for your attention, have a nice day! Stefano Zappa. Stefano Zappa IT Specialist CAE - TT-3 Industrie Saleri Italo S.p.A. Phone: +39 0308250480 Fax: +39 0308250466 This message contains confidential information and is intended only for users(a)ovirt.org, infra(a)ovirt.org, devel(a)ovirt.org. If you are not users(a)ovirt.org, infra(a)ovirt.org, devel(a)ovirt.org you should not disseminate, distribute or copy this e-mail. Please notify Stefano.Zappa(a)saleri.it immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Stefano Zappa therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version. *PRIVACY INFORMATION ART. 13 EU REG. 2016/679* We inform you that the personal data contained in the present and subsequent electronic communications will be processed in compliance with the EU Regulation 2016/679, for the purpose of and only for the time necessary to allow the sender to carry out the activities connected to the existing commercial relationships. The provision of personal data is not mandatory. However, failure to provide them determines the impossibility of achieving the aforementioned purpose. With regard to these data, is allowed the exercise of the rights set out in art. 13 and from the articles from 15 to 22 of EU Regulation 2016/679 and in particular the right to request the access to, updating, rectification and erasure of your personal data, as well as the right to object to processing and to lodge a complaint with the Supervisory Authority, by sending an e-mail to privacy(a)saleri.it. Data Controller of your personal data is Industrie Saleri Italo S.p.a., with registered office in via Ruca, 406 - 25065 Lumezzane (BS). _______________________________________________ Users mailing list -- users(a)ovirt.org To unsubscribe send an email to users-leave(a)ovirt.org Privacy Statement: https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: https://www.ovirt.org/community/about/community- guidelines/ List Archives: https://lists.ovirt.org/archives/list/users@ovirt.org/ message/WE2SAB6IGVLFSLBK7334PMH2O4ADP62Z/