Re: [Users] Problem setting up a ovirt node / engine on a Minimal CentOS 6.5

So you wanted to install engine and compute node (vdsm) on the same host? If the anser to the above is yes you may want to checkout the all-in-one installation option for ovirt-engine. HTH Am 21.02.2014 15:18, schrieb Andy Michielsen: > Hello, > > Maybe I'm not asking my question at the right guy's but here I go. > > > I installed a clean CentOS 6.5 on a new DELL server and wanted to use it to > install oVirt 3.3.x.x > I changed the ifcfg-eth0 file to get it connected to the internet and did a > yum -y update. > > Then I added some repositories to get the oVirt packages : > - yum -y install > http://dl.fedoraproject.org/pub/epel/6/x86_64/epel-release-6-8.noarch.rpm > - yum -y install > http://resources.ovirt.org/releases/ovirt-release-el.noarch.rpm > > Installed the ovirt engine first with yum -y install ovirt-engine and than > run the setup by engine-setup. > > So far so good. > > I can log into the oVirt website and see that there is nothing there. > > Then I want to install yum -y install vdsm vdsm-cli and wanted to add the > ifcfg-ovirtmgmt bridge and that's where thing go wrong. > > Obviously I did something wrong but I don't know what. Any help would be > greatly appriciated. > > Kind regards. -- Mit freundlichen Grüßen / Regards Sven Kieske Systemadministrator Mittwald CM Service GmbH & Co. KG Königsberger Straße 6 32339 Espelkamp T: +49-5772-293-100 F: +49-5772-293-333 https://www.mittwald.de Geschäftsführer: Robert Meyer St.Nr.: 331/5721/1033, USt-IdNr.: DE814773217, HRA 6640, AG Bad Oeynhausen Komplementärin: Robert Meyer Verwaltungs GmbH, HRB 13260, AG Bad Oeynhausen _______________________________________________ Users mailing list Users(a)ovirt.org http://lists.ovirt.org/mailman/listinfo/users