So you wanted to install engine and compute node (vdsm) on the same host? If the anser to the above is yes you may want to checkout the all-in-one installation option for ovirt-engine. HTH Am 21.02.2014 15:18, schrieb Andy Michielsen: > Hello, > > Maybe I'm not asking my question at the right guy's but here I go. > > > I installed a clean CentOS 6.5 on a new DELL server and wanted to use it to > install oVirt 3.3.x.x > I changed the ifcfg-eth0 file to get it connected to the internet and did a > yum -y update. > > Then I added some repositories to get the oVirt packages : > - yum -y install > http://dl.fedoraproject.org/pub/epel/6/x86_64/epel-release-6-8.noarch.rpm > - yum -y install > http://resources.ovirt.org/releases/ovirt-release-el.noarch.rpm > > Installed the ovirt engine first with yum -y install ovirt-engine and than > run the setup by engine-setup. > > So far so good. > > I can log into the oVirt website and see that there is nothing there. > > Then I want to install yum -y install vdsm vdsm-cli and wanted to add the > ifcfg-ovirtmgmt bridge and that's where thing go wrong. > > Obviously I did something wrong but I don't know what. Any help would be > greatly appriciated. > > Kind regards. -- Mit freundlichen Grüßen / Regards Sven Kieske Systemadministrator Mittwald CM Service GmbH & Co. KG Königsberger Straße 6 32339 Espelkamp T: +49-5772-293-100 F: +49-5772-293-333 https://www.mittwald.de Geschäftsführer: Robert Meyer St.Nr.: 331/5721/1033, USt-IdNr.: DE814773217, HRA 6640, AG Bad Oeynhausen Komplementärin: Robert Meyer Verwaltungs GmbH, HRB 13260, AG Bad Oeynhausen _______________________________________________ Users mailing list Users(a)ovirt.org http://lists.ovirt.org/mailman/listinfo/users

Hello, Maybe I'm not asking my question at the right guy's but here I go. I installed a clean CentOS 6.5 on a new DELL server and wanted to use it to install oVirt 3.3.x.x I changed the ifcfg-eth0 file to get it connected to the internet and did a yum -y update. Then I added some repositories to get the oVirt packages : - yum -y install http://dl.fedoraproject.org/pub/epel/6/x86_64/epel-release-6-8.noarch.rpm - yum -y install http://resources.ovirt.org/releases/ovirt-release-el.noarch.rpm Installed the ovirt engine first with yum -y install ovirt-engine and than run the setup by engine-setup. So far so good. I can log into the oVirt website and see that there is nothing there. Then I want to install yum -y install vdsm vdsm-cli and wanted to add the ifcfg-ovirtmgmt bridge and that's where thing go wrong. Obviously I did something wrong but I don't know what. Any help would be greatly appriciated. Kind regards.