2:08 p.m.
On Sat, Dec 17, 2016 at 9:25 PM, Fred Rolland <frolland(a)redhat.com> wrote:
Hi,
What is the storage type ?
Thanks,
Fred
On Dec 16, 2016 3:43 PM, "Stefan Wandl"
<swandl(a)ubimet.com> wrote:
> Hi,
>
> i have currently two issues with templates:
>
> 1) I cannot create VMs from Templates with Pre-Allocated Disks. I have a
> VM with 2 Preallocated and one Thin Provisioned Disk.
> Whenever i create a new template from this Machine all Disks are changed
> to Thin Provisoned inside of the Template.
>
When you create a template you can create the type of te disk, maybe you
chose cow?
During the VM create in the resource tab i can only choose between
Thin
> and Clone,
>
If you created raw disk, you will have a raw disk after cloning the
template.
since the disks are all changed to Thin Provisioned it is impossible
to
> create Pre-Allocated Disks with the Template.
>
> Can the behavior of the "Make Template" somehow be changed?
>
>
> 3) I use cloud-init with a couple of settings in the "Intital Run" for
> the installation of the machines. Whenever i create a new VM from template
> inside of the Admin GUI the "Use Cloud-Init/Sysprep" is enabled and
> prefilled. Thats fine.
> When i use the same template inside of the User GUI the "Use
> Cloud-Init/Sysprep" is disabled and all the Cloud-Init settings are empty.
>
> Should it work that way or is it a bug?
>
It sounds like a bug, adding Michal.
>
>
>
> ------------------------------------------------------------
> --------------------------------------------------------
> *UBIMET GmbH* - weather matters
> Stefan Wandl
> Information & Process Management
>
> A-1220 Wien • Donau-City-Straße 11 • Tel +43 1 263 11 22 479
> <callto:+43%201%20263%2011%2022%20479>
> swandl(a)ubimet.com • www.ubimet.com
> ------------------------------------------------------------
> --------------------------------------------------------
>
> The information contained in this message (including any attachments) is
> confidential and may be legally privileged or otherwise protected from
> disclosure. This message is intended solely for the addressee(s). If you
> are not the intended recipient, please notify the sender by return e-mail
> and delete this message from your system. Any unauthorized use,
> reproduction, or dissemination of this message is strictly prohibited.
> Please note that e-mails are susceptible to change. UBIMET GmbH shall not
> be liable for the improper or incomplete transmission of the information
> contained in this communication, nor shall it be liable for any delay in
> its receipt. UBIMET GmbH accepts no liability for loss or damage caused by
> software viruses and you are advised to carry out a virus check on any
> attachments contained in this message.
>
> _______________________________________________
> Users mailing list
> Users(a)ovirt.org
> http://lists.ovirt.org/mailman/listinfo/users
>
>
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
