
So you wanted to install engine and compute node (vdsm) on the same host? If the anser to the above is yes you may want to checkout the all-in-one installation option for ovirt-engine. HTH Am 21.02.2014 15:18, schrieb Andy Michielsen:
Hello,
Maybe I'm not asking my question at the right guy's but here I go.
I installed a clean CentOS 6.5 on a new DELL server and wanted to use it to install oVirt 3.3.x.x I changed the ifcfg-eth0 file to get it connected to the internet and did a yum -y update.
Then I added some repositories to get the oVirt packages : - yum -y install http://dl.fedoraproject.org/pub/epel/6/x86_64/epel-release-6-8.noarch.rpm - yum -y install http://resources.ovirt.org/releases/ovirt-release-el.noarch.rpm
Installed the ovirt engine first with yum -y install ovirt-engine and than run the setup by engine-setup.
So far so good.
I can log into the oVirt website and see that there is nothing there.
Then I want to install yum -y install vdsm vdsm-cli and wanted to add the ifcfg-ovirtmgmt bridge and that's where thing go wrong.
Obviously I did something wrong but I don't know what. Any help would be greatly appriciated.
Kind regards.
-- Mit freundlichen Grüßen / Regards Sven Kieske Systemadministrator Mittwald CM Service GmbH & Co. KG Königsberger Straße 6 32339 Espelkamp T: +49-5772-293-100 F: +49-5772-293-333 https://www.mittwald.de Geschäftsführer: Robert Meyer St.Nr.: 331/5721/1033, USt-IdNr.: DE814773217, HRA 6640, AG Bad Oeynhausen Komplementärin: Robert Meyer Verwaltungs GmbH, HRB 13260, AG Bad Oeynhausen