[ovirt-users] 4.5.1 hyperconverged install failure "No valid network interface has been found"

TL;DR hyperconverged install. Gluster install works, hosted engine fails with "no valid network interface has ben found" I have a three node hyperconverged cluster that had previously been running oVirt 4.4 successfully. A fully wipe and clean install of 4.5.1 was attempted with: ovirt-node-ng-installer-4.5.1-2022062306.el8.iso On each node, there are two statically configured 10Gb ethernet interfaces (and some unused 1Gb interfaces) enp5s0f0 - ovirt management/VM network (default gateway is on this network) enp5s0f1 - gluster network (isolated network) Name resolution is done via /etc/hosts on each node: 100.64.0.7 node1-ovirt node1-ovirt.local 100.64.0.8 node2-ovirt node2-ovirt.local 100.64.0.9 node3-ovirt node3-ovirt.local 100.79.192.1 node1-ovirt-storage node1-ovirt-storage.local 100.79.192.2 node2-ovirt-storage node2-ovirt-storage.local 100.79.192.3 node3-ovirt-storage node3-ovirt-storage.local Attempting to install the hosted engine fails with: *System data could not be retrieved!* *No valid network interface has been found* *If you are using Bonds or VLANs Use the following naming conventions:* - VLAN interfaces: physical_device.VLAN_ID (for example, eth0.23, eth1.128, enp3s0.50) - Bond interfaces: bond*number* (for example, bond0, bond1) - VLANs on bond interfaces: bond*number*.VLAN_ID (for example, bond0.50, bond1.128) * Supported bond modes: active-backup, balance-xor, broadcast, 802.3ad * Networking teaming is not supported and will cause errors Here is the network setup on node1: [root@node1-ovirt ovirt]# ip -4 addr ls 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever 6: enp5s0f0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 inet 100.64.0.7/20 brd 100.64.15.255 scope global noprefixroute enp5s0f0 valid_lft forever preferred_lft forever 7: enp5s0f1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 inet 100.79.192.1/24 brd 100.79.192.255 scope global noprefixroute enp5s0f1 valid_lft forever preferred_lft forever 8: virbr0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN group default qlen 1000 inet 192.168.122.1/24 brd 192.168.122.255 scope global virbr0 valid_lft forever preferred_lft forever [root@node1-ovirt ovirt]# My troubleshooting is that the failure is /probably/ coming from this file, but I'm not sure why: /usr/share/ansible/collections/ansible_collections/ovirt/ovirt/roles/hosted_engine_setup/tasks/pre_checks/001_validate_network_interfaces.yml Help? Thanks! Dax Kelson