[Kimchi-devel] [PATCH] Use the right firewall-cmd command to open Kimchi ports

[Crístian Viana]

Reviewed-by: Crístian Viana <vianac at linux.vnet.ibm.com>

On 16-03-2015 12:18, Aline Manera wrote:
> When trying to open Kimchi ports following the instructions on README on
> RHEL 7.1 I got the following error:
>
> [root at rhel7-vm ~]# sudo firewall-cmd --add-port=8000 --permanent
> bad port (most likely missing protocol), correct syntax is portid[-portid]/protocol
>
> The same behavior was identified on Fedora 21.
>
> So update the firewall-cmd commands to properly guide user on opening
> Kimchi ports.
>
> Signed-off-by: Aline Manera <alinefm at linux.vnet.ibm.com>