[Users] Unable to finish AIO 3.3.0 - VDSM

[Jason Brooks]

----- Original Message -----
> From: "Dan Kenigsberg" <danken at redhat.com>
> To: "Jason Brooks" <jbrooks at redhat.com>
> Cc: "Nicholas Kesick" <cybertimber2000 at hotmail.com>, "oVirt Mailing List" <users at ovirt.org>
> Sent: Monday, September 23, 2013 1:23:28 PM
> Subject: Re: [Users] Unable to finish AIO 3.3.0 - VDSM
> 
> On Mon, Sep 23, 2013 at 03:29:10PM -0400, Jason Brooks wrote:
> > 
> > 
> > > 
> > > Hi Nicholas, I just installed an F19 AIO without any problem. My install
> > > was
> > > only minimal, though. I restored my snapshot to pre-ovirt install and
> > > added
> > > the "standard" group, rebooted, installed, and vdsm still installed
> > > normally.
> > > 
> > > I'm wondering if it makes a difference if the system starts out with
> > > minimal+standard, rather than starting out minimal and adding standard
> > > after...
> > > 
> > > This is with dhcp addressing.
> > 
> > Another difference -- my AIO machine has nics w/ the regular eth0 naming --
> > don't know if the biosdevname bits could be causing an issue...
> 
> Would I be wrong to assume that you had
> /etc/sysconfig/network-scripts/ifcfg-eth0 defined before installation
> began?

My systems do always have this defined before installation begins. I almost always
do PXE installs of Fedora. Wonder how it differs from a DVD install...

Jason




> 
>