[ovirt-devel] Re: [CQ]: 108705, 9 (ovirt-engine) failed "ovirt-master" system tests, but isn't the failure root cause

Hi Didi, I manage to reproduce this error locally. Is there something you would like me to check?

Regards, Galit On Sun, May 3, 2020 at 1:37 PM Yedidyah Bar David <didi(a)redhat.com&gt; wrote: > On Sun, May 3, 2020 at 12:57 PM oVirt Jenkins <jenkins(a)ovirt.org&gt; wrote: > > > > A system test invoked by the "ovirt-master" change queue including > change > > 108705,9 (ovirt-engine) failed. However, this change seems not to be > the root > > cause for this failure. Change 107284,12 (ovirt-engine) that this change > > depends on or is based on, was detected as the cause of the testing > failures. > > > > This change had been removed from the testing queue. Artifacts built > from this > > change will not be released until either change 107284,12 > (ovirt-engine) is > > fixed and this change is updated to refer to or rebased on the fixed > version, > > or this change is modified to no longer depend on it. > > > > For further details about the change see: > > https://gerrit.ovirt.org/#/c/108705/9 > > > > For further details about the change that seems to be the root cause > behind the > > testing failures see: > > https://gerrit.ovirt.org/#/c/107284/12 > > > > For failed test results see: > > https://jenkins.ovirt.org/job/ovirt-master_change-queue-tester/23505/ > > The engine did manage to run ssh-copy-id to both host-0 and host-1, but > then failed, a few seconds later, while running ansible: > > > https://jenkins.ovirt.org/job/ovirt-master_change-queue-tester/23505/arti... > > 2020-05-03 05:54:49,779-04 ERROR > [org.ovirt.engine.core.common.utils.ansible.AnsibleExecutor] > (EE-ManagedThreadFactory-engine-Thread-1) [13ea1de1] Error executing > playbook: Failed to add host to inventory: SSH timeout waiting for > response from 'lago-basic-suite-master-host-0' > > A few other lines along this one, as well as similar ones for host-1, > do not give (me) more information. > > lago did manage to collect logs from both hosts, a few seconds later. > vdsm logs are empty, messages does not give me a clue. > > What is the timeout on trying to ssh (with ansible)? engine.log shows > only 1-2 seconds from start to timeout. Perhaps we should make it a bit > longer? > > Best regards, > -- > Didi > _______________________________________________ > Devel mailing list -- devel(a)ovirt.org > To unsubscribe send an email to devel-leave(a)ovirt.org > Privacy Statement: https://www.ovirt.org/privacy-policy.html > oVirt Code of Conduct: > https://www.ovirt.org/community/about/community-guidelines/ > List Archives: > https://lists.ovirt.org/archives/list/devel@ovirt.org/message/WQ3JDHUPHR4... > -- GALIT ROSENTHAL SOFTWARE ENGINEER Red Hat <https://www.redhat.com/> galit(a)redhat.com T: 972-9-7692230 <https://red.ht/sig>