[ovirt-users] After trying to use OVS can't recover a node to use ovirtmgmt

Hello, I've unsucessfully tried in a node to use ovs, now I want to switch back to use ovirtmgmt but I cant. for some reason my node is not operational and I have the following on ovirt-engine.log: ------------------------------0---------------> ERROR [org.ovirt.engine.core.bll.SetNonOperationalVdsCommand] (DefaultQuartzScheduler7) [1472e53b] Host 'labarq01.lda' is set to Non-Operational, it is missing the following networks: 'ovirtmgmt' <------------------------------0------------------- When I was installing OVS for some reason the ovirtmgmt was removed I recreated it and its functional. 5: ovirtmgmt: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP qlen 1000 link/ether a0:8c:fd:c7:1a:00 brd ff:ff:ff:ff:ff:ff inet 10.3.38.11/24 brd 10.3.38.255 scope global ovirtmgmt valid_lft forever preferred_lft forever inet6 fe80::a28c:fdff:fec7:1a00/64 scope link valid_lft forever preferred_lft forever root@labarq01 ovirt-engine]# cat /etc/sysconfig/network-scripts/ifcfg-ovirtmgmt # Generated by VDSM version 4.19.31-1.el7.centos DEVICE=ovirtmgmt TYPE=Bridge DELAY=0 STP=off ONBOOT=yes IPADDR=10.3.38.11 NETMASK=255.255.255.0 GATEWAY=10.3.38.1 BOOTPROTO=none MTU=1500 DEFROUTE=yes NM_CONTROLLED=no IPV6INIT=yes IPV6_AUTOCONF=yes DNS1=10.12.1.110 DNS2=10.113.24.145 root@labarq01 ovirt-engine]# brctl show bridge name bridge id STP enabled interfaces ;vdsmdummy; 8000.000000000000 no ovirtmgmt 8000.a08cfdc71a00 no eno1 I'm using Centos 7 and ovirt 4.1.7 the rest of the nodes work properly. Is there any way to configure this network for this host manually? Thank you in advance. Best regards