Hello,
I've unsucessfully tried in a node to use ovs, now I want to switch back to
use ovirtmgmt but I cant.
for some reason my node is not operational and I have the following on
ovirt-engine.log:
------------------------------0--------------->
ERROR [org.ovirt.engine.core.bll.SetNonOperationalVdsCommand]
(DefaultQuartzScheduler7) [1472e53b] Host 'labarq01.lda' is set to
Non-Operational, it is missing the following networks: 'ovirtmgmt'
<------------------------------0-------------------
When I was installing OVS for some reason the ovirtmgmt was removed I
recreated it and its functional.
5: ovirtmgmt: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue
state UP qlen 1000
link/ether a0:8c:fd:c7:1a:00 brd ff:ff:ff:ff:ff:ff
inet 10.3.38.11/24 brd 10.3.38.255 scope global ovirtmgmt
valid_lft forever preferred_lft forever
inet6 fe80::a28c:fdff:fec7:1a00/64 scope link
valid_lft forever preferred_lft forever
root@labarq01 ovirt-engine]# cat
/etc/sysconfig/network-scripts/ifcfg-ovirtmgmt
# Generated by VDSM version 4.19.31-1.el7.centos
DEVICE=ovirtmgmt
TYPE=Bridge
DELAY=0
STP=off
ONBOOT=yes
IPADDR=10.3.38.11
NETMASK=255.255.255.0
GATEWAY=10.3.38.1
BOOTPROTO=none
MTU=1500
DEFROUTE=yes
NM_CONTROLLED=no
IPV6INIT=yes
IPV6_AUTOCONF=yes
DNS1=10.12.1.110
DNS2=10.113.24.145
root@labarq01 ovirt-engine]# brctl show
bridge name bridge id STP enabled interfaces
;vdsmdummy; 8000.000000000000 no
ovirtmgmt 8000.a08cfdc71a00 no eno1
I'm using Centos 7 and ovirt 4.1.7 the rest of the nodes work properly.
Is there any way to configure this network for this host manually?
Thank you in advance.
Best regards
Show replies by date