[ovirt-users] Re: Trunk VLAN Ovirt 4.2

After nodes were joined the ovirt cluster, you must : 1) create networks within Datacenter tab. There you set the VLAN tagging, with the VLAN ID. You can also specify the network usage (migration, management, vm etc.). You must also assign network to the cluster containing nodes. 2) assign these networks to nodes from Host>Setup Host Networks, without assign an IP, being the "transport" to the vm that will run on the nodes. At the same time, or before, or later, you can create the bond from the same point. Choose the right bond mode, depending on the switch config and supported modes on ovirt. After these task, networks will go up in the cluster, so you can start to deploy vm and assign vm to these "trunked" networks, assigning them IP addresses, fixed or via DHCP. Hope this help you. Roberto Nunin Gruppo Comifar ICT Infrastructure Manager Nucleo Ind. Sant'Atto - S.Nicolò A Tordino 64100, Teramo (TE) - Italy Phone: +39 0861 204 415 int: 2415 Fax: +39 02 3333 0804 Mobile: +39 3483019957 Email: roberto.nunin(a)comifar.it Web: www.gruppocomifar.it<http:// www.gruppocomifar.it> On Mon, Jan 14, 2019 at 4:08 AM +0100, "Sebastian Antunez N." <antunez.sebastian@gmail.com<mailto:antunez.sebastian@gmail.com>> wrote: Hello Guys Have a lab with 6 nodes Ovirt 4.2. All nodes have 4 nic 1GB and two nic are for Management and and I will assign two nic in bonding for VM traffic My problem is the following. The switch Cisco have 2 VLAN (56 and 57) and I need to be able to create a new network with the two vlan but I am not clear how to make it so that the vlan go through this created network. I have read that I must create a network with vlan 56 for example and assign it an IP, and then create the network with vlan 57 and assign it an IP and later assign it to bonding. Is what I indicate or should another process be correct? Thanks for the help. Sebastian ________________________________ Questo messaggio e' indirizzato esclusivamente al destinatario indicato e potrebbe contenere informazioni confidenziali, riservate o proprietarie. Qualora la presente venisse ricevuta per errore, si prega di segnalarlo immediatamente al mittente, cancellando l'originale e ogni sua copia e distruggendo eventuali copie cartacee. Ogni altro uso e' strettamente proibito e potrebbe essere fonte di violazione di legge. This message is for the designated recipient only and may contain privileged, proprietary, or otherwise private information. If you have received it in error, please notify the sender immediately, deleting the original and all copies and destroying any hard copies. Any other use is strictly prohibited and may be unlawful.