[ovirt-users] Re: vdsmd.service stuck in state: activating

I've always used ovirt with enabled ssl until now, and I've done so only because it's instructed by oVirt doc: https://www.ovirt.org/develop/developer-guide/vdsm/installing-vdsm-from-r... Having ssl enabled, still lead to what I think are the same errors, as you can see from the following and the attached logs. # vi /etc/vdsm/vdsm.conf [vars] ssl = true Restarting vdsmd will lead to failure (expectedly, as we've just switched ssl mode): # systemctl restart vdsmd Job for vdsmd.service failed because the control process exited with error code. See "systemctl status vdsmd.service" and "journalctl -xe" for details. So I'll reconfigure it: # vdsm-tool configure --force Checking configuration status... abrt is already configured for vdsm lvm is configured for vdsm libvirt is already configured for vdsm FAILED: conflicting vdsm and libvirt-qemu tls configuration. vdsm.conf with ssl=True requires the following changes: libvirtd.conf: listen_tcp=0, auth_tcp="sasl", listen_tls=1 qemu.conf: spice_tls=1. Current revision of multipath.conf detected, preserving Running configure... Reconfiguration of abrt is done. Reconfiguration of passwd is done. Reconfiguration of libvirt is done. Done configuring modules to VDSM.

As a quick check to see if everything has been configured correctly, I run again the configuration and this time there won't be anything to be done: # vdsm-tool configure --force

Checking configuration status... abrt is already configured for vdsm lvm is configured for vdsm libvirt is already configured for vdsm SUCCESS: ssl configured to true. No conflicts Current revision of multipath.conf detected, preserving Running configure... Reconfiguration of abrt is done. Reconfiguration of passwd is done. Reconfiguration of libvirt is done. Done configuring modules to VDSM.

Starting vdsmd still fails: # systemctl start vdsmd Job for vdsmd.service failed because the control process exited with error code. See "systemctl status vdsmd.service" and "journalctl -xe" for details. I've attached new logs for ssl enabled as xz archive.

Il giorno mer 7 nov 2018 alle ore 12:07 Nir Soffer <nsoffer(a)redhat.com&gt; ha scritto: > On Tue, Nov 6, 2018 at 3:58 PM Giannino Stoppani <sceglimilano(a)gmail.com&gt; > wrote: > >> Thank you all for the replies, I'm sticking to bottom posting with 70 >> columns wide line, with the exception of log lines. >> >> On Wed, Oct 31, 2018 at 11:48 AM Shani Leviim <sleviim(a)redhat.com&gt; >> wrote: >> >>> I think that this one can help : >>> https://www.ovirt.org/develop/developer-guide/vdsm/installing-vdsm-from-r... >>> Make sure you've installed libvirt from the rpm as appeared on the link >>> there. >>> >> >> I've followed your link, from my notes I see I've already tested it in >> the beginning of my messing. I've set 'ssl = false' in >> /etc/vdsm/vdsm.conf >> > > Disabling ssl is not supported configuration. If can be used for debugging > in development environment but it should not be used in production. > This configuration is also not tested, so it is likely to break. > > Even if you disable ssl in vdsm, other parts of the system require ssl, > like > ovirt-imageio. > > Nir >