Re: [Users] SSL error when adding host (oVirt 3.1)
On 07/09/2012 10:59 PM, Justin Clift wrote:
On 10/07/2012, at 5:53 AM, Itamar Heim wrote:
<snip>
>> Installation was performed from F17 using the "from rpm" instructions
here:
>>
>> http://www.ovirt.org/wiki/Installing_VDSM_from_rpm
>>
>> _Guessing_ the "ssl = false" bit is causing the problem. No idea how
to
>> either enable ssl in the host, or turn it off in Engine though. (or anything
>> else that works :>)
>
> why would you have ssl = false anywhere?
That's what the above steps in the "Installing VDSM from rpm" instructions
say to do. My understanding of the pieces in oVirt isn't yet great enough
to do stuff _without_ following instructions yet. ;)
are you installing them both on same host?
"this (these) steps are usually not required when installing VDSM on
another host than ovirt-engine"
if you do want on same host, this is old and should probably be
superseded by:
http://www.ovirt.org/wiki/Feature/AllInOne
(not sure has a wiki on how to use, but basically you just need to
install the allinon setup plugin rpm adn run installer