8:22 a.m.
On Tue, Jul 21, 2015 at 9:02 AM, Alan Murrell <lists(a)murrell.ca> wrote:
I have installed a hosted engine setup on a single host. The host
is
running CentOS 7 and the engine is Centos 6.6.
Prior to running through the engine deployment, I created the
ifcfg-ovirtmgmt file and set my primary network interface, "eno1", as part
of that bridge. I did this because when I have attempted deployment in
the past, the deployment ran into some problems creating the 'ovirtmgmt'
bridge.
If at all possible, please try that again. If there are still unsolved
bugs, we'd
like to know.
I do recall during the deployment script, the output did indicate
that it saw the 'ovirtmgmt' bridge was already present. The deployment
*seemed* to go OK.
You might want to check/post also the output of 'vdsClient -s 0 getVdsCaps',
especially 'bridges', 'networks' and 'nics' there.
Upon logging in to the admin portal, my host is not initialised; it has a
red "X". The error indicated that the "ovirtmgmt" bridge was not
assigned
to an interface.
When I click on the host then "Network Interfaces", all my network
interfaces are showing red "down" arrows (which makes sense if the host is
not initialised). When I click on "Setup Network Interfaces", it lists my
physical interfaces on the left and on the right, under "Unassigned Logical
networks" is "ovirtmgmt".
I Assigned "ovirtmgmt" to interface "eno1", but when I click
"OK", I get the
following message:
--- START ---
Error while executing action:
hosted_engine_1:
* Network address must be specified when using static ip
--- END ---
I tried to edit "ovirtmgmt" and assign the static IP, but the same error
comes up.
Here are my files for 'ifcfg-eno1' and 'ifcfg-ovirtmgmt':
--- START ifcfg-ovirtmgmt ---
TYPE="Bridge"
BOOTPROTO="static"
DEVICE="ovirtmgmt"
ONBOOT="yes"
DELAY="0"
IPADDR="10.215.1.21"
NETMASK="255.255.255.0"
GATEWAY="10.215.1.1"
--- END ifcfg-ovirtmgmt ---
--- START ifcfg-eno1 ---
TYPE="Ethernet"
BOOTPROTO="none"
DEVICE="eno1"
ONBOOT="yes"
BRIDGE="ovirtmgmt"
--- END ifcfg-eno1 ---
I don't have currently a setup with static addresses, so it's just a guess:
Perhaps you need 'NETWORK='?
Here is the output of 'brctl show':
--- START ---
bridge name bridge id STP enabled interfaces
;vdsmdummy; 8000.000000000000 no
ovirtmgmt 8000.fc4dd4f2e238 no eno1
vnet0
--- END ---
It appears that the bridge exists, but the system (VDSM?) is not recognising
it nor able to create it.
Any ideas what the issue is? If you need a look at something else, please
let me know. I may not be able to post it until later (my server is remote
to me until Wednesday so I won;t have immediate access), but I will post
whatever else you need to have a look at.
Well, you can check/post also vdsm and engine logs.
Adding Dan.
Best,
--
Didi