Re: [Users] Choosing which network to run VM migration on ovirt 3.1
Hi Yuval
i think migrate was only the RAM not die virtual hard disk.
For so an scenario you need one separate Ovirt Engine (Management) one separate Storage
and two Ovirt Nodes.
An then you can build a HA Solution to reduce a Node failure. the single point of failure
there will still give
Eg. Storage, Ovirt Engine and Network. But i think you can cluster the application and
storage from the nodes. Using drbd, ucarp, etc.
greeting Andreas
----- Ursprüngliche Mail -----
Von: "Yuval M" <yuvalme(a)gmail.com>
An: users(a)ovirt.org
CC: "Limor Gavish" <lgavish(a)gmail.com>
Gesendet: Sonntag, 6. Januar 2013 21:08:48
Betreff: [Users] Choosing which network to run VM migration on ovirt 3.1
Hi,
I'm running the following setup:
2 hosts,
each has 2 physical NICs,
the first NIC (which is bridged to ovirtmgmt) is a 100Mbps ethernet card connected to a
switch (and to the internet)
the 2nd NIC is a fast Infiniband card which is connected back-to-back to the other host.
both links are running fine, and I managed to have the 2nd host mount the storage via the
fast link.
The problem is that VM migration takes place over the slow link.
How do I configure the cluster so that the migration uses the fast link?
I've already created a network using the web interface. the migration still uses the
slow link.
Thanks,
Yuval
_______________________________________________
Users mailing list
Users(a)ovirt.org
http://lists.ovirt.org/mailman/listinfo/users